Welcome to the TBoltUSA Tech Database! To visit our store, click here, or use the menus at the top of the page.
How to re-install the clutch washers / Plate on a rear clutch motor
With the clutch basket in place:
1)Place the thicker slotted washer on the main shaft and turn 1/8 turn to expose the slots in the shaft
2)Place the thinner pronged washer points down or tward the engine
3)Place the Hub with threaded towers down / centered
4)Stack plates starting with fiber first , aligning inner tabs
5)Place hub down , washer , tighten lock nut
Mechanical Theory:
The Basket can spin freely on the main shaft
and the hub is locked to the main shaft
the two only connect via the friction of the clutch plates
Clutch Info:
Always oil all surfaces of the Drive and driven plates during install