TRC - Cradle Mount Frame Adapter for KLX/DRZ110 and KLX110L

I do not normally post reviews but wanted to give a shout out to the staff at TBOLT because, unfortunately the first one I purchased had a very SMALL defect. HOWEVER it was no issue at all because customer service pushed out a swap within 3 days of reaching out with my issue. The second one I promptly received fit perfectly! Product is built very well and adds much needed support to my mini.

Just recently bought two of these. One for my sons klx 110L and his friends klx110. They bolt right on and work well. Comes with all the hardware you need for bolt on application. I double checked the case hole depth before I bolted my sons on just to make sure bolts weren't too long. They were just the perfect length. This is a must have item for the klx110. If you have a klx you should have one of these on it especially if your a teen or adult riding it.

Ordered this for my son’s 2017 KLX110L. Installed it during first oil change and it went on with zero issues. Everything lined up perfectly and now I shouldn’t have to worry about him ripping out the peg mount.

Great Product
Totally saved my cases

Great product. Bolts right up. Strong and solid cradle and comes with longer bolts. TboltUSA is awesome.

Just put it on my bike today when i received it.. thought id have to get longer bolts still but nope comes with everything and its very sturdy i am very pleased with it definitely not ripping the foot pegs out again, would strongly recommend.

This is a MUST have for All KLX110s
Rock solid
Fits right up with T Bolts
KLX & DRZ 110 Foot Peg Mounts W/Pegs
[TRC-0406]

This thing is solid and built like a brick. I run it on my 110 and jump it and put my bike through hell and this cradle holds up amazing! Get one, it gives you peace of mind when you're about to air that huge jump..

This is a very sturdy part that protects a vulnerable area on my 2010 KLX 110L. Without it, there have been many reports of case damage due to torn out cross brace bolts that secure the foot pegs and side stand mount to the engine. It was a very straightforward install. A couple of hints: 1. Use a bungee cord over the top of the seat and secured to each footpeg to keep the cross brace in place. 2. Do not use a stand during final fit up or fasteners may bind. 3. Fit up all fasteners hand tight to insure alignment, then tighten 4 casing bolts before the two rear large bolts.

Oh yeah, during an oil filter change, you only need to loosen the cradle mounting fasteners a bit, then remove the forward two bolts to slide out the belly skid plate sandwiched between the cradle and the engine casing so you can get access to the oil filter. Very easy.